The correct operation method of Crawler shot blasting machine

The crawler belt type shot blasting machine does not required a pit. Before installation, just use a level to check the horizontal and vertical levels of the ground. The machine has assembled the shot blasting chamber and turbines into one before leaving the factory. When receiving the goods for installation, bolt the elevator with the elevator part on the shot blasting chamber. When installing the bucket elevator, attention should be paid to adjusting the upper end of the active pulley bearing seat to keep it level and avoid belt deviation. And then bolt the separator and the upper part of bucket elevator.

Install the shot supply valve on the separator, insert the shot recovery pipe into the steel pipe behind the shot blasting chamber, and connect all the pipes according to the dust removal system diagram. After the separation of waste, users can prepare a waste box for disposal the wastes by separation.

Load the appropriate number of workpieces to the shot blasting chamber, and the machine is started, the workpieces begin to flip under the drive of the crawler belt.

The projectile beam formed by the turbine at high speed uniformly impacts on the workpiece surface, to achieve the finishing effect. The abrasives and broken particles are sifted through the small holes on the rubber belt or metal belt into the steel plate mesh at the bottom, through the screw conveyor into the bucket elevator, and then separated by the hopper of elevator into the separator for separation.

When the separator is operating normally, there should be no gap in the projectile flow curtain. If the full curtain cannot be formed, the serial number should be adjusted until the full curtain is formed to obtain an outstanding separation effect. The large material after the projectile screen should be removed regularly.

The bag dust collector adopts Venturi principle of Venturi tube pulse back blowing ash cleaning system, which has the advantages of low filtration speed, high filtration precision and good ash cleaning effect. The dust is filtered by the fan into the dust collector, the clean air is discharged into the atmosphere, and the dust on the filter bag falls into the dust collecting box at the bottom of the dust collector. The user can remove the dust regularly, and the waste sand flows out from the waste pipe. The mixed abrasive with broken particles is recycled into the chamber by the recovery pipe, return to the separator for separation, and the clean abrasive will re-enter to the shot blasting machine through the shot supply gate for reuse.